Digital Logic Converter Unit
Military aircraft need to be able to depend on and maintain communications for broadband, frequency hopping V/UHF secure communications. In concert with Cooper Antennas range of tuneable antennas, the 21-151-06 digital Logic Converter Unit (LCU) receives frequency information from all versions of the ARC210 radio and tunes the antenna to the desired frequency which in turn optimizes the gain of the antenna.
The digital LCU validates the control signals from the ARC210 radio (no wiring changes or grounding of pins for version), extracts the frequency information, translates it to a tuning command, and provides the required drive signals to tune the antenna via the parallel bus at the output connector. The LCU contains extensive built in diagnostic capability (BIT) which monitor the input data, PSU status, internal health monitor, in addition to monitoring each of the output drive lines. The BIT status of the unit is fed back to the transceiver.
The LCU is constructed from aluminium alloy with internal filter and protection PCBs to maximise EMC performance.
- Suitable for any airborne application
- Operates with all versions of the ARC210 including the ARC210 Gen 5
- Designed to MIL-STD-810, MIL-STD-461 and MIL-STD-704
- Incorporates the latest FPGA technology
- Incorporates continuous and interruptive BIT functionality
|DC Power Input||
Normal Working Voltage: 22 to 29 Volts dc
Emergency Working Voltage: 18 to 29 Volts dc
Protection: Reverse polarity and transient protection are incorporated in the design. Power interrupts in accordance with MIL-STD-704F; the state of the antenna outputs will remain as set but may be reduced in level during the power interruption.
|Serial Control||The frequency information is transmitted via a 1 MHz Manchester encoded differential serial bit stream|
|ARC-210 Interface||Irrespective of the version or ARC-210 that is used, all wiring from the ARC210 to the LCU is exactly the same. The LCU interprets the radio version and adjust automatically|
|Antenna Tuning Interface||
The antenna tuning interface consists of nine lines of antenna drive signals output on connector J3 and a single return line. Tuning of the antenna is achieved by applying forward or reverse bias to the pin-diode switches in the antenna
High Level +300 V Reverse Bias
Low Level -220 mA Forward Bias constant current source
|LCU DC Connectors||
J1 : D38999/42WB35PN
J2 : D38999/42WB5PN
J3 : D38999/42WB35SN
Emissions: CE101, CE102, CE106, RE101, RE102
Susceptibility: CS101, CS114, CS106, RS101, RS103
Electromagnetic Pulse: RS105
|Operational Temperature||-54°C to +71°C|
|Length x Width x Height||159.7 x 77.8 x 68.6 mm|
|Weight (max)||0.75 kg|
- Urethane Lusterless Black